Where to obtain parameter for the x-full thermal model

PyBaMM Q&A Parameters
1

I am struggling to understand how I would go about getting parameters for this model. I haven’t found a parameter example set in the repo, and also could not map these parameters:

'Negative current collector surface heat transfer coefficient [W.m-2.K-1]',
               'Negative tab heat transfer coefficient [W.m-2.K-1]',
               'Negative tab width [m]',
               'Edge heat transfer coefficient [W.m-2.K-1]',
               'Positive current collector surface heat transfer coefficient [W.m-2.K-1]',
               'Positive tab heat transfer coefficient [W.m-2.K-1]',
               'Positive tab width [m]'

I think they are derived from this paper https://doi.org/10.1137/20M1336898? But I could not match the names to the parameters in the paper except for the heat transfer coefficients.

Edit: I have now found the Table SM1 in the supplementary material and the parameters are somewhat given there, but is it correct that the heat transfer coefficient is the same everywhere? There is only one value given.

Thanks :slight_smile: